




ABEC and Kegel Pulleys
Replacement wheel pulleys for ONSRA belt drive boards, available with 32, 40 or 45 teeth and with a KEGEL or ABEC wheel interface. Pick the interface that matches the core of your wheels and the tooth count that matches your riding style.
What's in the box
- 2 wheel pulleys (one set, same size and interface)
- 2 bearings (10 mm) already pressed into each pulley
Details
- Sizes: 32T KEGEL, 40T KEGEL, 45T KEGEL, 40T ABEC, 45T ABEC
- Material: strong ABS plastic, low friction on the belt
- KEGEL pulleys only fit Kegel-core wheels, ABEC pulleys only fit ABEC-core wheels
Which tooth count?
- More teeth (45T): more acceleration and hill power, lower top speed
- Fewer teeth (32T): higher top speed, less acceleration
- Rule of thumb: smaller wheels go with smaller pulleys, bigger wheels with bigger pulleys.
Matching belt sizes (HTD 5M)
| Board | 32T | 40T | 45T |
|---|---|---|---|
| BLACK Carve 3 / 3 PRO | 265 / 270 | 285 | 300 |
| VELAR | – | 285 | 300 |
| Challenger / Challenger PRO | – | 270 | 285 |
| BLACK Carve 2 | – | 270 | 285 |
A different pulley size needs a different belt length. Boards shipped after November 2022 use the BLACK Carve 3 setup. Not sure? Check the number printed on your current belt or send us a photo.
ONSRA Challenger 2.0
On the Challenger 2.0 the motor pulley has 14 teeth on both versions. The Street version runs a 40T wheel pulley (ratio about 2.86), the All-Terrain version a 60T wheel pulley (ratio about 4.29). The 60T pulley for AT wheels is a separate part.
Fitting tips
- Swap pulleys as a pair so both sides have the same ratio.
- Fit the matching belt, then check the belt tension and alignment before your first ride.
- Check the pulley screws again after the first few rides.
Videos
How to change the pulleys on an ONSRA BLACK Carve belt drive.
97 mm wheels with a 40T pulley: more pull uphill.
Pairs well with

ABEC and Kegel Pulleys
Built to ride.
Engineered for power, built to last.
